Fanuc Symbol CAPi T Operators Manual

B–63304EN/02
8. CAXIS FAPT FUNCTION BC–AXIS FAPT FUNCTION
511
POSITION (X–AXIS) DX= 20.. . . . . . . .
DEPTH DT= 15.. . . . . . . . . . . . . . . . . . . .
HOLE DIAMETER WT= 10.. . . . . . . . . .
THROUGH HOLE TH= 0 . . . . . . . . . . .
CIRCKE CENTER CD= 1 . . . . . . . . . . .
C.CENTER (X–AXIS) CDX= 40.. . . . . . . .
C.CENTER (C–AXIS) CC= 20.. . . . . . . .
PLANE (Z–AXIS) PZ= 20.. . . . . . . . . . .
INTERVAL AB= 0 . . . . . . . . . . . . . . . . .
QUANTITY AC= 4 . . . . . . . . . . . . . . . .
INITIAL ANGLE A1= 0.. . . . . . . . . . . .
FINAL ANGLE AE= 270.. . . . . . . . . . . . .
Following NC data is created for drill holes of above parameters.
Similar NC data is also created for other machining types of Center
Drilling, Tapping, Reaming or Boring.
C–AXIS Drilling type 1 (Using fixed cycle)
(C–DRILLING) ;
N0004G28H0.;
G50X150.Z150.C0.;
G0T0202;
G97S1500M13;
X72.111;
Z2.;
C33.39;
G98G83Z–38.282.R0.P1000F150;
(G17GG98G82Z–38.282R2.P1000F150.)
C56.31;
X44.721C63.435;
C26.565;
G0Z150.;
X150.;
T0200;
M1;
² MTF2203, 2204 (Drill cycle) is referred to.
*see note
MTF2017 (rapid traverse, cutting feed move
command block) is referred to.
² MTF2203, 2204 (Drill cycle) is referred to.
NOTE
This command block is replaces by the next command block
in parentheses in case of FS–15–TFB/TTFB.

Leave a Reply

Your email address will not be published. Required fields are marked *