Fanuc Symbol CAPi T Operators Manual

B–63304EN/02
8. CAXIS FAPT FUNCTION BC–AXIS FAPT FUNCTION
513
a. C–AXIS REANIN
(C–REAMER);
N0004G28H0.;
G50X150.Z150.C0.;
G0T0202;
G97S1300M13;
X70.;
Z2.;
C45.;
Z–18.;
G1Z–33.F40.;
Z–18.F200.;
G0C135.;
G1Z–33.F40.;
Z–18.F200.:
G0C225.;
G1Z–33.F40.;
Z–18.F200.;
G0C315.;
G1Z–33.F40.;
Z–18.F200.;
G0Z2.;
Z150.;
X150.;
0T0200;
M1;
² MTF2017(rapid traverse,cutting feed move command block)is referred to.
² MTF2031,2032(approaching in one axis at a time)is referred to.
² F=[Cutting Feed Rate] X [Value in system parameter No.392.]
b. C–AXIS BORING type 1 (Using Fixed Cycle)
(C–BORING) ;
N0004G28H0.;
G50X150.Z150.C0.;
G0T0202;
G97S1200M13;
X70.;
Z2.;
C45.;
Z–18.;
G98G85Z–38.R0.P1000F120.;
(G17GG98G89Z–33.R–18.P1000F120.)
C135.;
C225.;
G0Z2.;
Z150.;
X150.;
T0200;
M1;
² MTF2216, 2217 (Fixed boring cycle 1) is referred to.
² MTF2031, 2032 (approaching in one axis at a time) is referred to.
² MTF2216, 2217 (Fixed boring cycle 1) is referred to.
*see note
NOTE
This command block is replaced by the next command block
in parentheses in case of FS15–TFB/TTFB.

Leave a Reply

Your email address will not be published. Required fields are marked *