Fanuc Symbol CAPi T Operators Manual

C–AXIS FAPT FUNCTION
B–63304EN/02
8. CAXIS FAPT FUNCTION B
514
c. C–AXIS BORING type 1 (Not using Fixed Cycle)
(C–BORING) ;
N0004G28H0.;
G50X150.Z150.C0.;
G0T0202;
G97S1200M13;
X70.;
Z2.;
C45.;
Z–18.;
G1Z–33.F120.;
G4U0.001;
Z–18.F240.;
G0C135.;
G1Z–33.F120.;
G4U0.001;
Z–18.F240.;
G0C225.;
G1Z–33.F120.;
G4U0.001;
Z–18.F240.;
G0C315.;
G1Z–33.F120.;
G4U0.001;
Z–18.F240.;
G0Z2.;
Z150.;
X150.;
T0200;
M1;
² F=[Cutting Feed Rate] X [Value in system parameter No.396.]
² MTF2017 (rapid traverse, cutting feed move command block) is referred to.
² MTF2027 (Drill cycle) is referred to.
d. C–AXIS BORING type 2 (Using Fixed Cycle)
This example is valid for FS15TFB/TTFB only.
(C–BORING) ;
N0004G28H0.;
G50X150.Z150.C0.;
G0T0202;
G97S1200M13;
X70.;
Z2.;
C45.;
Z–18.;
G178G98G86.1Z–33.R–18.Q2000P1000F120.;
(G17GG98G86.1Z–33.R–18.12.P1000F120.)
C135.;
C225.;
C315.;
G0Z2.;
Z150.;
X150.;
T0200;
M1;
² MTF2218, 2219 (Fixed boring cycle 2)
is referred to.
² MTF2031, 2032 (approaching in one axis at a time) is referred to.
² MTF2218, 2219 (Fixed boring cycle 2) is referred to.
*see note

Leave a Reply

Your email address will not be published. Required fields are marked *