Fanuc Symbol CAPi T Operators Manual

B–63304EN/02
8. CAXIS FAPT FUNCTION BC–AXIS FAPT FUNCTION
517
(REAMER)
TOOL TYPE TP;REAMER(M). . . . . . . . . . . . .
TOOL MATERIAL MT;. . . . . . . .
TOOL DIAMETER DT=. . . . . . . .
CUT LENGTH LT=. . . . . . . . . . .
PECK DEPTH LE=. . . . . . . . . . . .
(BORING)
TOOL TYPE TP; BORING (M). . . . . . . . . . . . .
TOOL MATERIAL MT;. . . . . . . .
TOOL DIAMETER DT=. . . . . . . .
CUT WIDTH DS=. . . . . . . . . . . . .
CUT LENGTH LT=. . . . . . . . . . .
Enter other parameters in the same manner as other milling tools.
Refer to chapter V section 2.2, Tool Display and Setting, of the
OPERATOR’s MANUAL for CONVERSATIONAL AUTOMATIC
PROGRAMMING FUNCTION FOR LATHE, B–61804E–2, for
detailed procedure.
(3)Tooling Information
Tolling data necessary for CAXIS REAMING and C–AXIS
BORING can be specified in the same manner as that of C–AXIS
FAPT FUNCTION. Refer to chapter V section 2.4, Tooling
Information Display and Setting, of the OPERATORs MANUAL for
CONVERSATIONAL AUTOMATIC PROGRAMMING
FUNCTION FOR LATHE, B–61804E–2, for detailed procedure.

Leave a Reply

Your email address will not be published. Required fields are marked *