Fanuc Symbol CAPi T Operators Manual

PROGRAMMING AND
OPERATION BY Symbolic FAPT
B–63304EN/02
3. EXECUTION OF
Symbolic FAPT
34
(b)STANDARD SURFACE ROUGHNESS NR =. . . . .
(1.
, 2. , 3. , 4. )
This is a question used to select the surface roughness. Input the
number of
marks on the machining drawing. For example, key in
“2” if nearly all areas of machining drawing have
. It is possible
to skip this question using system parameter No.10.
(c) DRAWING FORMAT DF =. . . . . . . . . . . . . . . . . . .
This question is used to select the drawing format.
When the horizontal figure drawing is performed:
1. 2.
When the vertical figure drawing is performed:
In the case of horizontal drawing, select the drawing format 1 or 3 and
2 or 4 to easily input the dimension data on programming while the
dimension value of drawing is written based on the left and right sides,
respectively. This question can be skipped by setting of the system
parameter No.9.

Leave a Reply

Your email address will not be published. Required fields are marked *