Fanuc Symbol CAPi T Operators Manual

B–63304EN/02
1. OVERVIEWY–AXIS FAPT FUNCTION
531
If the Caxis angles (phase) of the desired machining planes are specified,
as well as the figure to be machined, the figure can be machined on the
specified planes.
The following figure shows holes of identical figures machined on plane
A (0°), plane B (90°), plane C (180°), and plane D (270°). Only a single
hole figure is programmed for this machining.
1.3
ROTATING THE
MACHINING PLANE

Leave a Reply

Your email address will not be published. Required fields are marked *