Fanuc Symbol CAPi T Operators Manual

B–63304EN/02
2. PART FIGURE DEFINITION
(MENU 2)
Y–AXIS FAPT FUNCTION
535
WARNING
1 After entering part figure data, check the entered data.
Failure to enter correct data may result in the tool colliding
with the workpiece and/or machine, or forced machining
occurring, possibly causing damage to the workpiece,
machine, and/or tool itself, or injury to the user.
2 For a conversational program for which machining process
data has been prepared, if part figure data is modified, the
cutting area specified in the machining definition may be
changed. Operating the machine based on NC data in
memory, with an incorrect cutting area specified, may result
in the tool colliding with the workpiece and/or machine,
possibly causing damage to the machine and/or tool itself,
or injury to the user.
CAUTION
1 When entering threading data, check the data that is
automatically calculated by pressing the [OUTER
THREAD], [INNER THREAD], or [SQUARE THREAD] soft
key. If this data is incorrect, the workpiece cannot be
machined properly.
2 Check the figure data that is automatically inserted by the
batch input function for chamfering/corner R. If this data is
incorrect, the workpiece cannot be machined properly.
3 Check the figure data that is automatically created by the
pattern figure input function. If this data is incorrect, the
workpiece cannot be machined properly.
4 Check the data that is automatically set by the neck corner
input function. If this data is incorrect, the workpiece cannot
be machined properly.
2.2
SPECIFYING THE
Y–AXIS FIGURE
DATA

Leave a Reply

Your email address will not be published. Required fields are marked *