Fanuc Symbol CAPi T Operators Manual

Y–AXIS FAPT FUNCTION
B–63304EN/02
2. PART FIGURE DEFINITION
(MENU 2)
536
The data input screen, featuring a figure for Yaxis machining (excluding
the machining of a figure on a side face or end face) is configured as shown
below:
Soft keys
ESCAPE: Returns the display to the program menu screen. (The
input data becomes valid.)
BACK PAGE: Returns the display to Y axis machining menu screen.
When this key is depressed in the course of data setting,
the already input data becomes invalid. (It becomes valid
when “CHECK” is pressed, however.)
CHECK: Draws the figure according to the input data.
(Only patterns defined here are drawn.)
CURSOR°
CURSOR±: Moves the cursor forward and backward.
NEXT PAGE: Y axis machining menu screen proceeds.
(1)Screen for specifying holes on a circumference on the end face
Specify the following values:
PLANE (ZAXIS): PZ = Position of the drilling plane
DEPTH: DT = Hole depth
THREADING DIA: WT = Hole diameter

Leave a Reply

Your email address will not be published. Required fields are marked *