Fanuc Symbol CAPi T Operators Manual

B–63304EN/02
2. PART FIGURE DEFINITION
(MENU 2)
Y–AXIS FAPT FUNCTION
537
THROUGH HOLE: TH = 1 for through hole, 0 for blind hole
CENTER DRILL: CG = 1 for center drilling, 0 for other
machining
TAPPING: TA = 1 for tapping, 0 for other machining
C.CENTER (XAXIS): CDX = Center of the circumference (diameter)
(Y–AXIS): CY = Center of the circumference (radius)
CIRCLE RADIUS: RD = Radius of the circumference
INTERVAL: AB = Whether multiple holes are drilled at
regular intervals (0 for regular intervals,
1 for irregular intervals)
HOLE QUANTITY: AC = Number of holes (Up to 100 for drilling
at regular intervals, up to 6 for drilling at
irregular intervals)
ANGLE: A1 = Hole position (Angle, the angle of the
first hole if multiple holes are to be
drilled)
A2 = Position of the second hole (for drilling
at irregular intervals)
A3 = Position of the third hole (for drilling at
irregular intervals)
A4 = Position of the fourth hole (for drilling at
irregular intervals)
A5 = Position of the fifth hole (for drilling at
irregular intervals)
AE = Angle of the last hole if multiple holes
are drilled
POS.QUANTITY: NG = Number of phases (up to 6)
POSITION ANGLE: G1 = Position of the first phase (angle)
G2 = Position of the second phase (angle)
G3 = Position of the third phase (angle)
G4 = Position of the fourth phase (angle)
G5 = Position of the fifth phase (angle)
G6 = Position of the sixth phase (angle)

Leave a Reply

Your email address will not be published. Required fields are marked *