Fanuc Symbol CAPi T Operators Manual

B–63304EN/02
2. PART FIGURE DEFINITION
(MENU 2)
Y–AXIS FAPT FUNCTION
539
DX4=Position of the fourth hole (diameter, for
drilling at irregular intervals)
DX5=Position of the fifth hole (diameter, for
drilling at irregular intervals)
DX6=Position of the last hole if multiple holes
are drilled (diameter)
SHIFT COUNT: NS = Number of rows of holes to be drilled
SHIFT VALUE: SH= Interval between rows if multiple rows
of holes are drilled (radius)
POS.QUANTITY: NG = Number of phases (up to 6)
POSITION ANGLE: G1 = Position of the first phase (angle)
G2 = Position of the second phase (angle)
G3 = Position of the third phase (angle)
G4 = Position of the fourth phase (angle)
G5 = Position of the fifth phase (angle)
G6 = Position of the sixth phase (angle)
(3)Screen for specifying holes at desired positions on the end face
Specify the following values:
PLANE (ZAXIS): PZ = Position of the drilling plane

Leave a Reply

Your email address will not be published. Required fields are marked *