Fanuc Symbol CAPi T Operators Manual

Y–AXIS FAPT FUNCTION
B–63304EN/02
2. PART FIGURE DEFINITION
(MENU 2)
540
DEPTH: DT = Hole depth
THREADING DIA: WT = Hole diameter
THROUGH HOLE: TH = 1 for a through hole, 0 for a blind hole
CENTER DRILL: CG = 1 for center drilling, 0 for other
machining
TAPPING: TA = 1 for tapping, 0 for other machining
HOLE QUANTITY: AC = Number of holes (Up to 6)
HOLE POSITION: DX1=Position of the first hole
(X coordinate, diameter)
Y1 = Position of the first hole
(Y coordinate, radius)
DX2=Position of the second hole
(X coordinate, diameter)
Y2 = Position of the second hole
(Y coordinate, radius)
DX3=Position of the third hole
(X coordinate, diameter)
Y3 = Position of the third hole
(Y coordinate, radius)
DX4=Position of the fourth hole
(X coordinate, diameter)
Y4 = Position of the fourth hole
(Y coordinate, radius)
DX5=Position of the fifth hole
(X coordinate, diameter)
Y5 = Position of the fifth hole
(Y coordinate, radius)
DX6=Position of the sixth hole
(X coordinate, diameter)
Y6 = Position of the sixth hole
(Y coordinate, radius)
POS.QUANTITY: NG = Number of phases (up to 6)
POSITION ANGLE: G1 = Position of the first phase (angle)
G2 = Position of the second phase (angle)
G3 = Position of the third phase (angle)
G4 = Position of the fourth phase (angle)
G5 = Position of the fifth phase (angle)
G6 = Position of the sixth phase (angle)

Leave a Reply

Your email address will not be published. Required fields are marked *