Fanuc Symbol CAPi T Operators Manual

Y–AXIS FAPT FUNCTION
B–63304EN/02
2. PART FIGURE DEFINITION
(MENU 2)
542
A2 = Position of the second hole (for drilling
at irregular intervals)
A3 = Position of the third hole (for drilling at
irregular intervals)
A4 = Position of the fourth hole (for drilling at
irregular intervals)
A5 = Position of the fifth hole (for drilling at
irregular intervals)
AE = Angle of the last hole if multiple holes
are drilled
POS.QUANTITY: NG = Number of phases (up to 6)
POSITION ANGLE: G1 = Position of the first phase (angle)
G2 = Position of the second phase (angle)
G3 = Position of the third phase (angle)
G4 = Position of the fourth phase (angle)
G5 = Position of the fifth phase (angle)
G6 = Position of the sixth phase (angle)
(5)Screen for specifying holes on a line on the side face
Specify the following values:
PLANE (XAXIS): PDX=Position of the drilling plane (diameter)

Leave a Reply

Your email address will not be published. Required fields are marked *