Fanuc Symbol CAPi T Operators Manual

B–63304EN/02
2. PART FIGURE DEFINITION
(MENU 2)
Y–AXIS FAPT FUNCTION
543
DEPTH: DT = Hole depth
THREADING DIA: WT = Hole diameter
THROUGH HOLE: TH = 1 for a through hole, 0 for a blind hole
CENTER DRILL: CG = 1 for center drilling, 0 for other
machining
TAPPING: TA = 1 for tapping, 0 for other machining
POSITION (YAXIS): LY = Position of the line (radius)
INTERVAL: AB = Whether multiple holes are drilled at
regular intervals (0 for regular intervals,
1 for irregular intervals)
HOLE PITCH: PH = Interval between holes if they are drilled
at regular intervals
HOLE QUANTITY: AC = Number of holes (Up to 100 for drilling
at regular intervals, up to 6 for drilling at
irregular intervals)
HOLE POSITION: Z1 = Hole position (Zcoordinate, the
position of the first hole if multiple holes
are drilled)
Z2 = Position of the second hole (for drilling
at irregular intervals)
Z3 = Position of the third hole (for drilling at
irregular intervals)
Z4 = Position of the fourth hole (for drilling at
irregular intervals)
Z5 = Position of the fifth hole (for drilling at
irregular intervals)
Z6 = Position of the last hole if multiple holes
are drilled
SHIFT COUNT: NS = Number of rows of holes (up to 6 rows)
SHIFT VALUE: SH = Interval between rows if multiple rows
of holes are drilled
POS.QUANTITY: NG = Number of phases (up to 6)
POSITION ANGLE: G1 = Position of the first phase (angle)
G2 = Position of the second phase (angle)
G3 = Position of the third phase (angle)
G4 = Position of the fourth phase (angle)
G5 = Position of the fifth phase (angle)
G6 = Position of the sixth phase (angle)

Leave a Reply

Your email address will not be published. Required fields are marked *