Fanuc Symbol CAPi T Operators Manual

B–63304EN/02
2. PART FIGURE DEFINITION
(MENU 2)
Y–AXIS FAPT FUNCTION
545
Z3 = Position of the third hole (Z coordinate)
Y3 = Position of the third hole
(Y coordinate, radius)
Z4 = Position of the fourth hole (Z coordinate)
Y4 = Position of the fourth hole
(Y coordinate, radius)
Z5 = Position of the fifth hole (Z coordinate)
Y5 = Position of the fifth hole
(Y coordinate, radius)
Z6 = Position of the sixth hole (Z coordinate)
Y6 = Position of the sixth hole
(Y coordinate, radius)
POS.QUANTITY: NG = Number of phases (up to 6)
POSITION ANGLE: G1 = Position of the first phase (angle)
G2 = Position of the second phase (angle)
G3 = Position of the third phase (angle)
G4 = Position of the fourth phase (angle)
G5 = Position of the fifth phase (angle)
G6 = Position of the sixth phase (angle)

Leave a Reply

Your email address will not be published. Required fields are marked *