Fanuc Symbol CAPi T Operators Manual

B–63304EN/02
2. PART FIGURE DEFINITION
(MENU 2)
Y–AXIS FAPT FUNCTION
547
(8)Screen for specifying a pattern on a side face
Specify the following values:
PLANE (XAXIS): PDX=Position of the cutting plane (diameter)
DEPTH: DT = Cutting depth
T.CENTER (ZAXIS): SZ = Center of the rectangle
(Y–AXIS): SY = Center of the rectangle (radius)
TRACK WIDTH: W = Width of the rectangle
TRACK LENGTH: V = Length of the rectangle (radius)
ROUNDNESS: R = Radius of rounding if the corners are
rounded
POS.QUANTITY: NG = Number of phases (up to 6)
POSITION ANGLE: G1 = Position of the first phase (angle)
G2 = Position of the second phase (angle)
G3 = Position of the third phase (angle)
G4 = Position of the fourth phase (angle)
G5 = Position of the fifth phase (angle)
G6 = Position of the sixth phase (angle)

Leave a Reply

Your email address will not be published. Required fields are marked *