Fanuc Symbol CAPi T Operators Manual

Y–AXIS FAPT FUNCTION
B–63304EN/02
2. PART FIGURE DEFINITION
(MENU 2)
548
(9)Screen for checking a figure
When the [CHECK] soft key is pressed on the detailed figure data setting
screen, the figure is drawn according to the data set as shown above. If
a figure has been programmed with symbolic keys, the figure is drawn
simultaneously. The screen used for programming a figure does not have
the [CHECK] soft key. (See (12) and (13) below.)
The figure above shows the hole figures on the side face. The side view
on the left shows the hole positions in the YZ plane. The front view, on
the right, shows the position of the upper end of the hole with a dotted line.
If hole figures on the end face are displayed, the front view, on the right,
indicates the hole positions in the XY plane with circles (f). The side
view, on the left, uses a dotted line to indicate the upper end of the hole.
(10) Screen for checking an entire figure
When the [CHECK ALL] soft key is pressed on the Yaxis figure
definition menu screen, the figure selected with the cursor is drawn as
shown above.
To draw another programmed figure, press the [LAST FIGURE] or
[NEXT FIGURE] soft key.

Leave a Reply

Your email address will not be published. Required fields are marked *