Fanuc Symbol CAPi T Operators Manual

B–63304EN/02
2. PART FIGURE DEFINITION
(MENU 2)
Y–AXIS FAPT FUNCTION
549
(11) Screen for specifying a figure on an end face
The XY plane is drawn and the prompts relating to the figure elements and
coordinates are displayed. Input a desired figure, using symbolic keys.
The following figure elements can be specified:
³ ± ² ° ½ ¿ ¼ ¾
R C
Program a diameter as an X coordinate and a radius as a Y coordinate.
When the first element is specified, the CP = prompt is displayed. In
response to the prompt, specify the side to be cut, viewed from the start
point of the element.
CP = 0: On the right side, 1: On the left side, 2: On the element
Two or more singlestroke figures can be input. After a single figure
(single–stroke figure) has been defined, the ES = prompt is displayed.
In response to this prompt, press the INPUT key or the [NEXT PAGE] soft
key. The DEFINE ANOTHER FIGURE? prompt is displayed. In
response to this prompt, enter 1, INPUT. Then, repeat the procedure
used to define the first figure. To abandon the definition of a second
figure, enter 0, INPUT. Up to ten singlestroke figures can be
programmed. (See additional information 1.)
NOTE
Figures cannot be defined in directory mode.

Leave a Reply

Your email address will not be published. Required fields are marked *