Fanuc Symbol CAPi T Operators Manual

B–63304EN/02
3. EXECUTION OF
Symbolic FAPT
PROGRAMMING AND
OPERATION BY Symbolic FAPT
37
In the case of vertical drawing:
[MAT.NAME] Press this software key to see the name of 18th. .
material or thereafter while 18 or more blank
materials are registered.
[CURSOR ±] The cursor moves in forward direction.. . .
[CURSOR °] The cursor moves in backward direction.. . .
[NEXT PAGE] The next screen appears. If the input data contradicts. .
or there PAGE are undefined data, the following
message is displayed and it is not possible to move to
the next page: KEY IN AGAIN
NOTE
Normally, the next screen is automatically displayed when
all questions are answered on one screen. Press the
NEXT PAGE if it is not required to answer all questions or
data has been input to all questions. Also, it is possible to
allow the screen to keep being displayed for several
seconds after answering all questions or to disable
advancing to the next screen.
When the standard surface roughness or drawing format is
fixed, it is possible to skip these questions. See “Chapter
7 section 1.1 for the method of skipping the questions.
Set the system parameter No.19 to determine either of
horizontal or vertical drawing.

Leave a Reply

Your email address will not be published. Required fields are marked *