Fanuc Symbol CAPi T Operators Manual

Y–AXIS FAPT FUNCTION
B–63304EN/02
2. PART FIGURE DEFINITION
(MENU 2)
552
(b)Displaying figure elements
1) Displaying figure elements
A group of figure elements that can be drawn by a single keystroke is
displayed as a single figure and separated by a period.
The period cannot be directly entered nor deleted by using the operation
keys.
2) The start point of the first element of the first figure becomes the
machining start point when the NC data are created. Bearing this
in mind, define the part figure. The figures are machined in the
order in which they are defined.
3) To define a second or subsequent figure, specify the data of the start
point, then key in the figure element. This step differs from the
corresponding step for defining the first figure. (To define the first
figure, enter the figure element. Then, the prompt relating to the
start point is displayed.)
(c) Notes
The following restrictions are imposed on the definition of multiple
single–stroke figures:
NOTE
1 The side to be cut (CP) cannot be changed for each
individual figure.
2 A stepped figure cannot be defined. (For each definition)

Leave a Reply

Your email address will not be published. Required fields are marked *