Fanuc Symbol CAPi T Operators Manual

B–63304EN/02
4. DEFINING MACHINING
(MENU 4)
Y–AXIS FAPT FUNCTION
557
1) Tool data
A rotary tool is always used for Yaxis machining.
a. Yaxis center drilling: Use a center drill (M)(Note 1).
b. Yaxis drilling: Use a drill (M).
c. Yaxis tapping: Use a tap (M).
d. Yaxis pattern machining: Use an end mill (M).
e. Yaxis contouring: Use an end mill (M).
NOTE
1 (M) represents a rotary tool for milling
2 Use the same tool data and material data as that used for
C–axis machining. For details, see the chapter on the
C–axis FAPT function.
Enter the following tool figure data:
Center drill
TOOL DIAMETER: DT =
DRILL SIZE: DS =
CUT LENGTH: LT =
NOSE ANGLE: AT =
Drill
TOOL DIAMETER: DT =
CUT LENGTH: LT =
NOSE ANGLE: AT =
Tap
TOOL DIAMETER: DT =
CUT LENGTH: LT =
TECH LENGH: LE =
PITCH: PT =
End mill
TOOL DIAMETER: DT =
CUT WIDTH: DS =
TOOTH LENGTH: LT =
NUMBER OF TEETH: NT =
4.2
TOOL DATA

Leave a Reply

Your email address will not be published. Required fields are marked *