Fanuc Symbol CAPi T Operators Manual

Y–AXIS FAPT FUNCTION
B–63304EN/02
4. DEFINING MACHINING
(MENU 4)
558
Enter the tool setting position, as follows:
SETTING POSITION XS = (radius)
ZS = (radius)
YS = (radius)
2) Machining start position
Enter the following data:
MACHINING START POSITION
X coordinate DX0 = (diameter)
Z coordinate Z0 = (radius)
Y coordinate Y0 = (radius)
3) Passing points
Enter the following data. Program a diameter as an X coordinate and
a radius as a Y and Z coordinate.
Passing points to start machining
First point XA1 =
ZA1 =
YA1 =
Second point XA 2 =
ZA2 =
YA2 =
Passing points to end machining
First point XE1 =
ZE1 =
YE1 =
Second point XE2 =
ZE2 =
YE2 =

Leave a Reply

Your email address will not be published. Required fields are marked *