Fanuc Symbol CAPi T Operators Manual

B–63304EN/02
4. DEFINING MACHINING
(MENU 4)
Y–AXIS FAPT FUNCTION
561
c. Y–axis tapping
c–1. Tapping method 1
CLEARANCE: C1 = Clearance 1 (mm)
C2 = Clearance 2 (mm)
RPM: N = Tool rotational speed (rpm)
c–2. Tapping method 2 (rigid tapping)
CLEARANCE: C1 = Clearance 1 (mm)
C2 = Clearance 2 (mm)
RPM: N = Tool rotational speed (rpm)
c–3. Tapping method 3 (rigid tapping with pecking):
FANUC Series 15TFB/TTFB only
CLEARANCE: C1 = Clearance 1 (mm)
C2 = Clearance 2 (mm)
DEPTH OF CUT: D1 = Depth of cut (mm)
RPM: N = Tool rotational speed (rpm)
d. Y–axis pattern machining (grooving/pocketing)
d–1. Machining method 1 (See 2) Cutting patterns.”)
CUTTING DIRECTION: CD =Cutting direction
(See (*) Cf1 below.)
DIRECTION OF CUT: DR = Direction of cut
(See (*) Cf1 below.)
CLEARANCE: C1 = Clearance 1 (mm)
C2 = Clearance 2 (mm)
FINISHING ALLOWANCE: TS = Finishing allowance
(mm)
(See (*) Cf2 below.)
DEPTH OF CUT: D1 = Depth of cut (mm)
ROTATION SPEED: N = Tool rotational speed (rpm)
FEEDRATE: FT = Feed amount for each tooth
in the transverse direction
of the tool (mm/rev)
FR = Feed amount for each tooth
in the longitudinal
direction of the tool
(mm/rev)
d–2. Machining method 2 (See 2) Cutting patterns.”)
CUTTING DIRECTION: CD =Cutting direction (See (*)
Cf1 below.)
DIRECTION OF CUT: DR = Direction of cut
(See (*) Cf1 below.)
CLEARANCE: C1 = Clearance 1 (mm)
C2 = Clearance 2 (mm)
FINISHING ALLOWANCE: TS = Finishing allowance
(mm)
(See (*) Cf2 below.)
DEPTH OF CUT: D1 = Depth of cut (mm)

Leave a Reply

Your email address will not be published. Required fields are marked *