Fanuc Symbol CAPi T Operators Manual

B–63304EN/02
4. DEFINING MACHINING
(MENU 4)
Y–AXIS FAPT FUNCTION
565
d. Y–axis pattern machining (grooving/pocketing)
d–1. Machining methods
Machining method 1
Cutting is made in a single direction as shown below. Upon
the completion of this cutting, finishing is performed along
the contour except when the finishing allowance is set to 0
or is not defined. (See d3 below.)
Machining method 2
Cutting is performed in both directions, as shown below.
Upon the completion of this cutting, finishing is performed
along the contour except if the finishing allowance is set to
0 or is not defined. (See d3 below.)

Leave a Reply

Your email address will not be published. Required fields are marked *