Fanuc Symbol CAPi T Operators Manual

Y–AXIS FAPT FUNCTION
B–63304EN/02
4. DEFINING MACHINING
(MENU 4)
566
d–2. Clearance
For machining method 1 or 2, specify the following
clearances:
(1)In safety first mode (when bit 1 of system parameter 309 is
set to 0)
Blank figure
When safety first mode is selected, the tool is moved to a
position determined from the maximum dimension of the
blank outline, plus clearance C1, in rapid traverse mode
during approach/beginning of cutting. From this position,
the tool is moved in cutting feed mode to start cutting.
At the end of cutting/escape, the tool is returned to the
position determined from the maximum dimension of the
blank outline, plus clearance C1, in rapid traverse mode.

Leave a Reply

Your email address will not be published. Required fields are marked *