Fanuc Symbol CAPi T Operators Manual

B–63304EN/02
4. DEFINING MACHINING
(MENU 4)
Y–AXIS FAPT FUNCTION
567
(2)In efficiency first mode (when bit 1 of system parameter 309
is set to 1)
Blank figure
When efficiency first mode is selected, the tool is moved
through a position determined from the maximum dimension of
the blank outline, plus clearance C1, to a position determined
by the dimension of the cutting plane, plus clearance C1, in
rapid traverse mode at approach/beginning of cutting. From
that position, the tool is moved in the cutting feed mode to start
cutting.
At the end of cutting/escape, the tool is moved back through the
position determined from the dimension of the cutting plane,
plus clearance C1, to the position determined from the
maximum dimension of the blank outline, plus clearance C1, in
rapid traverse mode.

Leave a Reply

Your email address will not be published. Required fields are marked *