Fanuc Symbol CAPi T Operators Manual

B–63304EN/02
4. DEFINING MACHINING
(MENU 4)
Y–AXIS FAPT FUNCTION
573
The prompt relating to the approach/escape method is not
displayed if cutting is performed for the contour of the defined
figure.
(1)Direct approach (escape): SM = 1 (EM = 1)
A cut is directly made from the approach point to the
machining start position.
(2)Tangent approach (escape): SM = 1 (EM = 1)
The following prompt is added:
LENGTH: DT = Length in the direction of the tangent (mm or inch)
Cutting start point Machining start point
When the tool offset is executed by FAPT: Left side viewed
from the start point (CP = 1)
(3)Normal approach (escape): SM = 3 (EM = 3)
The following prompt is added:
LENGTH: DM = Length in the normal direction (mm or inch)
Part figure
When the tool offset is executed by FAPT: Right side viewed
from the start point (CP = 0)

Leave a Reply

Your email address will not be published. Required fields are marked *