Fanuc Symbol CAPi T Operators Manual

B–63304EN/02
4. DEFINING MACHINING
(MENU 4)
Y–AXIS FAPT FUNCTION
577
4) If cutter compensation is performed by the FAPT (bit 0 of MTF1305
is set to 0) and if cutting is executed along the contour of a closed blank
outline, the NC data are created so that the cutting end point (EP) meets
the cutting start point (SP) on the actual tool path.
Example: Cutting with normal approach/escape on the right side of a
blank outline

Leave a Reply

Your email address will not be published. Required fields are marked *