Fanuc Symbol CAPi T Operators Manual

PROGRAMMING AND
OPERATION BY Symbolic FAPT
B–63304EN/02
3. EXECUTION OF
Symbolic FAPT
40
(Example)
Start / End
point point
For a figure illustrated above, input the following keys along the drawing.
°
C
³
G
³
R
¿
G
³
T C
±
C
²
G
±
T C
²
G
±
C
²
The system will ask you necessary dimension, each time these figure
symbol keys are depressed.
(1)Contents of the question and the meaning of symbolic key.
Surface roughness
The system asks you the surface roughness, each time the figure
element symbol like a circle, a straight line, etc. is inputted. The
already designated standard surface roughness is automatically
displayed on the CRT screen at this time. If this value is allowable,
depress INPUT key only.
If you desire to change the surface roughness at that place only, select
the number of
symbols 1, 2, 3, or 4.
NOTE
By parameter setting on parameter No.0010, the question
on the surface roughness can be skipped. When this
question is skipped, the standard surface roughness is
employed.
Start point
The system asks you the start point at the first step of figure input only.
SDX Diameter value at start point. . . .
SZ Z value at start point. . . . . .
PE Whether a part exists on the left side or on right side along. . . . . .
a series of a figure profile to be inputted, is selected by
1 or 0.
The questions are made for the first figure element only, when a part
figure is inputted.

Leave a Reply

Your email address will not be published. Required fields are marked *