6. SYSTEM PARAMETERS
Y–AXIS FAPT FUNCTION
System parameters, setting data, and the MTF data,
described below, vary with the machine. For details, refer
to the manual provided by the machine tool builder. If these
data values are not set appropriately for the actual machine
being used, correct NC data cannot be prepared.
Machining with incorrect NC data may result in the tool
colliding with the workpiece, or forced machining occurring,
possibly causing damage to the machine and/or tool itself,
or injury to the user.
a. Parameters to enable the skipping of prompts
Parameter No. Format Initial value Description Remarks
0009 0, 1
00010000 Specify to skip a particular question.
Bit 0 Designation of index position
Bit 1 Designation of home position
Bit 2 Designation of machining start point
Bit 3 Designation of Y–axis index position and home
Bit 4 Selection of drawing format
Bit 6 Selection of standard surface roughness
0: Non skip
2 1 0