Fanuc Symbol CAPi T Operators Manual

B–63304EN/02
6. SYSTEM PARAMETERS
Y–AXIS FAPT FUNCTION
583
d. System parameters related to a process (for Yaxis machining)
Parameter No. Format Initial value Description Remarks
0400 0, 1
designation
(8 bits)
00100100 Y–axis center drilling process parameter
Bit 1 Coolant
0: Not used
1: Used
Bit 2 Cancellation of tool compensation
0: Not output
1: Output
Bit 3, 4 Approach
00: Simultaneous 1 axis
01: Simultaneous 2 axis
10: Simultaneous 3 axis
11: Simultaneous 4 axis
Bit 5, 6 Return relief
00: Simultaneous 1 axis
01: Simultaneous 2 axis
11, 10: Simultaneous 3 axis
Bit 7 The prompt relating to the passing point is:
0: Not displayed.
1: Displayed.
7 6 5 4 3 2 1 0
0
Bit
For Y–axis
machining
0401
0, 1
designation
(8 bits)
00100100
Y–axis drilling process parameter (refer to the
parameter No.400)
0402
0, 1
designation
(8 bits)
00100100
Y–axis tapping process parameter (refer to the
parameter No.400)
0403
0, 1
designation
(8 bits)
00100100
Y–axis pattern machining process parameter (refer to
the parameter No.400)
0404
0, 1
designation
(8 bits)
00100100
Y–axis contouring process parameter (refer to the
parameter No.400)
For Y–axis
machining
0405 to 0409
0, 1
designation
(8 bits)
00000000
Can’t use.
(Don’t change the data.)
0410
0, 1
designation
(8 bits)
00000000
Single step of Yaxis center drilling process
Bit 0 Process start
Bit 1 Just before approach
Bit 2 Just before escape
0: Not stopped
1: Stopped
7
0
6
0
5
0
4
0
3
0
2 1 0Bit
0411
0, 1
designation
(8 bits)
00000000
Single step of Yaxis drilling process (refer to the
parameter No.410)

Leave a Reply

Your email address will not be published. Required fields are marked *