Fanuc Symbol CAPi T Operators Manual

Y–AXIS FAPT FUNCTION
B–63304EN/02
6. SYSTEM PARAMETERS
584
Parameter No. RemarksDescriptionInitial valueFormat
0412
0, 1
designation
(8 bits)
00000000
Single step of Yaxis tapping process (refer to the
parameter No.410)
0413
0, 1
designation
(8 bits)
00000000
Single step of Yaxis pattern machining process (refer
to the parameter No.410)
0414
0, 1
designation
(8 bits)
00000000
Single step of Yaxis contouring process (refer to the
parameter No.410)
0415 to 0419
0, 1
designation
(8 bits)
00000000
Can’t use.
(Don’t change the data.)
2.
mm specification
Clearance amount (C1) of Y–axis
0420 Real number
0.08
inch specification
center drilling
Unit: mm or inch
0421 Real number Undefined
Can’t use.
(Don’t change the data.)
2.
mm specification
Clearance amount (C1) of Y–axis
0422 Real number
0.08
inch specification
drilling (machining method 1)
Unit: mm or inch
2.
mm specification
Clearance amount (C2) of Y–axis
0423 Real number
0.08
inch specification
drilling (machining method 1)
Unit: mm or inch
0424 Real number Undefined
Can’t use.
(Don’t change the data.)
2.
mm specification
Clearance amount (C1) of Y–axis
0425 Real number
0.08
inch specification
drilling (machining method 2)
Unit: mm or inch
2.
mm specification
Clearance amount (C2) of Y–axis
0426 Real number
0.08
inch specification
drilling (machining method 2)
Unit: mm or inch
2.
mm specification
Cutting depth (D1) of Y–axis
0427 Real number
0.08
inch specification
drilling (machining method 2)
Unit: mm or inch
2.
mm specification
Return relief amount (U) of
C–axis drilling (machining
0428 Real number
0.08
inch specification
method 2)
Unit: mm or inch
0429 Real number Undefined
Can’t use.
(Don’t change the data.)
2.
mm specification
Clearance amount (C1) of Y–axis
0430 Real number
0.08
inch specification
drilling (machining method 3)
Unit: mm or inch
2.
mm specification
Clearance amount (C2) of Y–axis
0431 Real number
0.08
inch specification
drilling (machining method 3)
Unit: mm or inch

Leave a Reply

Your email address will not be published. Required fields are marked *