Fanuc Symbol CAPi T Operators Manual

Y–AXIS FAPT FUNCTION
B–63304EN/02
7. NC MACHINE TOOL FILE (MTF)
588
Parameter No. DescriptionInitial valueFormat
1084 Integer 2
Movement sequence of sequential approach and escape along one or
two axes if the Yaxis FAPT function is used (valid only when
simultaneous approach or escape along one or two axes is specified in
system parameters 0400 to 0405)
0: Approach is always started from the XY plane.
Retraction is always started from the Zaxis.
1: End face
Approach: Tool axis (Z–axis) ³
Tool path (XY plane)
Escape: Tool path (XY plane) ³
Tool axis (Zaxis)
Side face
Approach: Tool axis (X–axis) ³
Tool path (ZY plane)
Escape: Tool path (ZY plane) ³
Tool axis (Xaxis)
2: Reverse movement sequence of 1 above (standard setting)
3: Approach is always started from the Z–axis.
Escape is always started from the XY plane.
4000. mm specification
Y–axis rapid traverse rate
1093 Integer
160. inch specification
Unit: mm or inch
1304
0, 1
designation
(8 bits)
00000011
In each process, the specifications of a canned drilling cycle
(C–axis or Yaxis) are:
0: Not used.
1: Used.
7 6 5 4 3 2 1 0
Center drilling
Drilling
1305
0, 1
designation
(8 bits)
00000000
Bit 0 For face milling (polar coordinate interpolation), finishing of
Y–axis pattern machining, and contouring, cutter compensation
is:
0: Carried out by the FAPT. (G40, G41, or G42 is not output.)
1: Carried out by the NC. (G40, G41, and G42 are output.)
7
0
6
0
5
0
4
0
3
0
2 1 0Bit
1350
Integer
(3 bits)
29
M code of the miscellaneous function for preparing for rigid tapping

Leave a Reply

Your email address will not be published. Required fields are marked *