Fanuc Symbol CAPi T Operators Manual

B–63304EN/02
7. NC MACHINE TOOL FILE (MTF)Y–AXIS FAPT FUNCTION
589
b. Function table (MTF2000 to MTF2999)
Parameter
No.
Description Remarks
2018
Outputs the block of move commands for
simultaneous approach along two axes.
Outputs the block of move commands for
simultaneous approach along four axes (with
Y–axis FAPT).
Rapid traverse
command,
coolant on, etc.
2019
Outputs the block of move commands for
simultaneous retraction along two axes.
Outputs the block of move commands for
simultaneous retraction along three axes (with
Y–axis FAPT).
Rapid traverse
command,
coolant off, etc.
2031
First motion of approach along an axis.
First motion of simultaneous approach along
one, two, or three axes as the same time (Y–axis)
2032
Second motion of approach along an axis.
Second or subsequent motion in simultaneous
approach along one, two, or three axes (Y–axis).
2033
First motion of retraction along an axis.
First motion of simultaneous retraction along one
or two axes (Y–axis).
2034
Second motion of retraction along an axis.
Second or subsequent motion of simultaneous
retraction along one or two axes (Y–axis)
2070 Beginning part of Yaxis machining (Note 1)
2071 Beginning part of Yaxis center drilling
2072 Beginning part of Yaxis drilling
2073 Beginning part of Yaxis tapping
2074 Beginning of Yaxis pattern
2075 Beginning of Yaxis contouring
2080 Not used
2081 End part of Yaxis center drilling
2082 End part of Yaxis drilling
2083 End part of Yaxis tapping
2084 End of Yaxis pattern
2085 End of Yaxis contouring
2110 Beginning of a turning process (Note 2)
2111 Beginning of a milling process (Note 3)
2212
Block in which cutter compensation for face
milling (polar coordinate interpolation), finishing
of Yaxis pattern, or Yaxis contouring is started.
Valid when bit 7
of MTF1305 is
set to 1
2213
Block in which cutter compensation for face
milling (polar coordinate interpolation), finishing
of Yaxis pattern, or Yaxis contouring is
canceled.

Leave a Reply

Your email address will not be published. Required fields are marked *