Fanuc Symbol CAPi T Operators Manual

B–63304EN/02
3. EXECUTION OF
Symbolic FAPT
PROGRAMMING AND
OPERATION BY Symbolic FAPT
41
Straight line
¾ ° ½ ² ³ ¼ ± ¿
(a) ELEMENT SYMBOL ES =. . . . . . . . . . .
Input an arrow along the profile figure when the system asks you
the above question.
For example, input
¾
INPUT
.
(b)SURFACE ROUGHNESS SR =. . . . . . .
Input the number of
marks indicating the surface roughness
when the system asks you the surface roughness.
(c) The system will ask you the following items sequentially, starting
with the top item by displaying these items on the CRT screen.
END POINT DX = Diameter value at end point. . . . . . . .
Z = Z value at end point
TANGENT LAST TL = Whether the profile touches. . . .
the last figure or not.
TANGENT NEXT TN = Whether the profile touches. . . .
the next figure or not.
ANGLE FROM Z A = Angle from Z axis. . . .
You have to input only the dimensions described on the drawing.
Depress
INPUT
key only, if a dimension is not found on the drawing.
The system does not always ask all the above items, depending
upon the input arrow directions, but it ask you necessary numerical
values only, and you have to input only those described on the
drawing.
(d)If data are insufficient, KEY IN AGAIN is displayed.
Circle
(a) ELEMENT SYMBOL ES =. . . . . . . . . . . . . .
Input either or key along the progressive direction of
the circle when the system asks you the above question.
(b)SURFACE ROUGHNESS SR =. . . . . . . . . .
Input the number of
marks indicating the surface roughness
when the system asks you the above question.
(c) END POINT DX = Diameter value at end point. . . . . . . .
Z = Z value at end point
TANGENT LAST TL = Whether the profile touches. . . .
the last arrow figure or not.
TANGENT NEXT TN = Whether the profile touches. . . .
the next arrow figure or not.
RADIUS R = Radius value of circle. . . . . . . . . . .
CENTER CDX = X value at circle center. . . . . . . . . . .
(diameter coordinate value)
CZ = Z value at circle center

Leave a Reply

Your email address will not be published. Required fields are marked *