Fanuc Symbol CAPi T Operators Manual

PROGRAMMING AND
OPERATION BY Symbolic FAPT
B–63304EN/02
3. EXECUTION OF
Symbolic FAPT
42
The system asks you the above questions sequentially by
displaying these items on the CRT screen. Input only such
dimensions as are known from the drawing. Depress
INPUT
key
only, if a corresponding dimension is not found on the drawing.
(d)If data are insufficient or if an invalid numerical value was input,
KEY IN AGAIN is displayed.
(e) The system asks you the following question when a profile figure
transfers from a straight line to circular arc or from a circular arc
to a circular arc.
SELECT START POINT or END POINT
(³: RIGHT ²: LEFT °: ABOVE ±: BELOW)
The parts figure input comprises two methods when a profile figure
transfers from a straight line or a circular arc.
When
½
keys were depressed;
The start point is either left side
or lower side”.
The start point is either right side
or upper side”.
When keys were depressed;
The start point is either “right
side” or lower side”.
The start point is either “left
side” or upper side”.
When the system asks you SELECT START POINT to identify the
following two possible methods from each other, you have to select
the right side (³), left side (²), above (°) or below (±) by the
³
,
²
,
°
, or
±
key.
Chamfering
C
Chamfering is designated by
C
, which indicates the capital of
chamfer.
(a) ELEMENT SYMBOL ES =. . . . . . . . . . . . . .
Answer
C
when the system asks you the above question.

Leave a Reply

Your email address will not be published. Required fields are marked *