Fanuc Symbol CAPi T Operators Manual

B–63304EN/02
2. SPECIFICATIONSBACK MACHINING FAPT
607
Input back machining base line ZP2 as well as primary machining base
line ZP.
In case of drawing format 2:
(1)Part figure input for turning
This is the same as standard input method. Define the final part figure
without primary machining and/or back machining.
(2)Part figure input for C axis machining
When defining figures of end face hole, end face groove, and front face
milling, the following question is displayed.
POSITION FS = (0: FRONT FACE, 1:REAR FACE). . . . .
This question indicates a face where the part figure exists.
Input FS = 0 in case of front face, input FS = 1 in case of rear face.
If you input FS = 0, input figure data as an image viewed from the front
face.
If you input FS = 1, input figure data as an image viewed from the rear
face.
For front view, draw an image viewed from the front side and express
front side figure with full lines and rear side figure with dotted lines.
2.1
PROGRAMMING
2.1.1
Material Data Input
(Menu No.1)
2.1.2
Part Figure Input
(Menu No.2)

Leave a Reply

Your email address will not be published. Required fields are marked *