Fanuc Symbol CAPi T Operators Manual

B–63304EN/02
2. SPECIFICATIONSBACK MACHINING FAPT
611
f) End face grooving
g) OD necking
Designate 45 degrees as tool mounting angle for OD grooving
(AS) or designate 45 degrees as that for end face grooving.
h) ID necking
Designate 45 degrees as tool mounting angle for ID grooving
(AS) or designate 45 degrees as that for end face grooving (AS).
i) OD threading
Same as tool data for primary machining
j) ID threading
AN’ is used if cutting is made along the groove center.
k) Face threading
Designate 0 degree as tool mounting angle for primary machining
(AS).
l) C axis machining/Y axis machining
The following question regarding mounting direction is displayed.
SETTING DIRECTION CP = (0: SIDE, 1: FRONT . . . . .
FACE, 2: REAR FACE)
For machining of rear end face, select 2.

Leave a Reply

Your email address will not be published. Required fields are marked *