Fanuc Symbol CAPi T Operators Manual

BACK MACHINING FAPT
B–63304EN/02
2. SPECIFICATIONS
614
Bit 7 for system parameter No.708 indicates whether or not back
machining is performed.
#7
708
#6 #5 #4 #3 #2 #1 #0
Bit 7 0 : Back machining is not performed.
1 : Back machining is performed.
If 708#7 = 0,
Machining is the same as former FAPT.
If 708#7 = 1,
D A question for indicating the end face position, FS = _ is added on
the figure definition screen for end face hole, end face groove, and
front face milling.
D A question for indicating a spindle to be used, SN = _ is added on
the tool data screen for machining definition.
D A question for indicating mounting angle, AS = _ is added on the
tool screen for drill and center drill.
D To the question of mounting position, CP = _ on the milling tool
data screen 2 (rear end face) can be input.
D If M code that has been designated in MTF No.1145 is executed in
animation drawing, the screen changes into back machining mode.
No.214: designates the X coordinate value of home position on the turret
1 back machining.
No.215: designates the Z coordinate value of home position on the turret
1 back machining.
No.216: designates the X coordinate value of home position on the turret
2 back machining.
No.217: designates the Z coordinate value of home position on the turret
2 back machining.
No.218: designates the X coordinate value of turret Index position on the
turret 1 back machining.
No.219: designates the Z coordinate value of turret Index position on the
turret 1 back machining.
No.220: designates the X coordinate value of turret Index position on the
turret 2 back machining.
No.221: designates the Z coordinate value of turret Index position on the
turret 2 back machining.
2.2
PARAMETERS, ETC.
2.2.1
System Parameters

Leave a Reply

Your email address will not be published. Required fields are marked *