Fanuc Symbol CAPi T Operators Manual

B–63304EN/02
2. SPECIFICATIONSBACK MACHINING FAPT
615
(System parameter)
No. Format Initial value Description Remarks
0802 Bit
00000000
If bit 0 = 0, the data for the second spindle is output, using the coordinate
system shown below.
If bit 0 = 1, the data for the second spindle is output, using the same
coordinate system as for the first spindle.
(If bit 0 = 0)
(If bit 0 = 1)
C–axis positive
direction
C–axis
positive
direction
C–axis
positive
direction
0740 Integer Undefined M code number (for the first spindle) for starting animated simulation for
lathe turning surface
Not to be specified if only simulation for lathe turning surface is
performed.
0741 Integer Undefined M code number (for the first spindle) for starting animated simulation for
C–axis end facing
0742 Integer Undefined M code number (for the first spindle) for starting animated simulation for
cylindrical surface
0743 Integer Undefined M code number for starting animated simulation for Yaxis end
facing/side facing
0771 Character Undefined List of axis names (for the first spindle) in animated simulation for
Y–axis end facing/side facing
(Specify axis names in the same sequence as for NC program axis
names for individual axes. Example: XZCY)
0736 Integer Undefined M code number (for the second spindle) for starting animated
simulation for lathe turning surface
Not to be specified if only animated simulation for lathe turning surface
is to be performed.
0737 Integer Undefined M code number (for the second spindle) for starting animated
simulation for Caxis end facing
0738 Integer Undefined M code number (for the second spindle) for starting animated
simulation for cylindrical surface
0749 Integer Undefined M code number (for the second spindle) for starting animated
simulation for Yaxis end facing/side facing

Leave a Reply

Your email address will not be published. Required fields are marked *