Fanuc Symbol CAPi T Operators Manual

B–63304EN/02
3. EXECUTION OF
Symbolic FAPT
PROGRAMMING AND
OPERATION BY Symbolic FAPT
45
Threading
T
Threading is designated by
T
, which indicates the capital of thread.
(a) ELEMENT SYMBOL ES =. . . . . . . . . . . . . .
Input
T
when the system asks you the above question.
(b)ON WHICH ELEMENT? EE = On which element is . . .
(0: LAST 1: NEXT) threading done?
LENGTH LT = Length of thread. . . . . . . . . . . . . . . .
LEAD LD = Lead of thread. . . . . . . . . . . . . . . . . . .
MULTIPLE NT = Number of threads of screw. . . . . . . . . . . . . .
The system asks you these questions, starting with the top item by
displaying them on CRT screen.
(c) ON NEXT ELEMENT orON LAST ELEMENT”?
T
is input before and after arrows, in general.
It indicates whether threading is made on a figure element to be
input or on the last figure element already input.
ON NEXT ELEMENT Input1”.. . . . . . .
ON LAST ELEMENT Input0”.. . . . . . .
Identify ON NEXT ELEMENT and ON LAST ELEMENT
from each other in the following illustration.
In case of the next element In case of the next element
In case of the last element In case of the last element
° °
° °
¾ ¾
¾ ¾
² ²
² ²
T T
T T

Leave a Reply

Your email address will not be published. Required fields are marked *