Fanuc Symbol CAPi T Operators Manual

B–63304EN/02
3. SETTING THE MACHINING
PROCEDURE
AUTOMATIC PROCESS
DETERMINATION FUNCTION
631
3
SETTING THE MACHINING PROCEDURE
Pressing the AUTO PROC. soft key displays the PROCESS SETTING
screen for setting the machining procedure. After the setting is
completed, pressing the EXEC soft key starts automatic process
determination. Manual input flags can also be set on this screen.
The PROCESS SETTING screen displays the setting data for the
machining method group number (No.000) and the machining procedure
data for the group (No.100 to 129, No.200 to 229, or No.300 to 329).
If the machining method group number is not defined, the group number
is determined by the material figure and the machining procedure data for
that group is displayed.
Round bar: Machining method group 1
(data in No.100 to 129)
Perforated round bar: Machining method group 2
(data in No.200 to 229)
Special material: Machining method group 3
(data in No.300 to 329)

Leave a Reply

Your email address will not be published. Required fields are marked *