Fanuc Symbol CAPi T Operators Manual

B–63304EN/02
4. DETAILS OF AUTOMATIC
PROCESS DETERMINATION
AND NOTES ON ITS USE
AUTOMATIC PROCESS
DETERMINATION FUNCTION
639
CAUTION
To determine processes automatically, set a value other
than 2 (machinig below an overhang) in system parameter
101. If 2 is specified, the correct cutting area for an
overhang is not automatically determined.
No.101: Data related to turning method
Initial value: 1
0 : Does not perform pocketing.
1 : Performs pocketing.
2 : Machines beneath overhang.
NOTE
1 For residual machining, the processes for sections a and b
in the figure below can be determined but processes using
inverse tools, such as the processes for sections c and d,
cannot be determined. Such processes should be manually
added after all processes are automatically determined.

Leave a Reply

Your email address will not be published. Required fields are marked *