Fanuc Symbol CAPi T Operators Manual

B–63304EN/02
4. DETAILS OF AUTOMATIC
PROCESS DETERMINATION
AND NOTES ON ITS USE
AUTOMATIC PROCESS
DETERMINATION FUNCTION
641
NOTE
4 If an area is still left uncut after the machining with the
inverse tool, no additional process for cutting that area
(shaded area in the figure below) can be automatically
determined.
Area (1) :
Cut with the normal tool
Area (2):
Cut with the inverse tool Shaded area: Left uncut
NOTE
5 The inverse process for balance cutting cannot be
automatically determined.

Leave a Reply

Your email address will not be published. Required fields are marked *