Fanuc Symbol CAPi T Operators Manual

AUTOMATIC PROCESS
DETERMINATION FUNCTION
B–63304EN/02
4. DETAILS OF AUTOMATIC
PROCESS DETERMINATION
AND NOTES ON ITS USE
642
(1)Always from +X to X along the end surface (from X to +X for the
inverse process)
(2)If outer surface machining is set in machining procedure data without
setting end surface machining, the end surface is cut in the same way
as for the outer surface machining.
(3)When the machining procedure data is set as shown below for outer
surface finishing, the end surface is cut from the outside to the center,
then the outer surface is cut with the same tool, if there is no inner
surface (Fig. a). If there is an inner surface, the end surface and outer
surface are cut in one continuous operation (Fig. b).
Setting of machining procedure data
End surface finishing
Outer surface finishing
Fig. a When there is no inner surface Fig. b When there is an inner surface
4.3
CUTTING DIRECTION

Leave a Reply

Your email address will not be published. Required fields are marked *