Fanuc Symbol CAPi T Operators Manual

B–63304EN/02
4. DETAILS OF AUTOMATIC
PROCESS DETERMINATION
AND NOTES ON ITS USE
AUTOMATIC PROCESS
DETERMINATION FUNCTION
643
To cut the end surface from the outside to the center and then cut the outer
surface with the same tool as shown in Fig.a even when there is an inner
surface, change the following setting data:
No.71: x 0 0 0 0 0 0 0
Method of outer surface finishing
0 : Cuts as shown in Fig.a or b depending on whether there is an inner
surface.
1 : Cuts as shown in Fig.a regardless of whether there is an inner surface.

Leave a Reply

Your email address will not be published. Required fields are marked *