Fanuc Symbol CAPi T Operators Manual

AUTOMATIC PROCESS
DETERMINATION FUNCTION
B–63304EN/02
4. DETAILS OF AUTOMATIC
PROCESS DETERMINATION
AND NOTES ON ITS USE
644
(1)Division direction for end surface machining (normal process)
The area is divided as shown in Fig.a when there is no inner surface
and as shown in Fig.b when there is an inner surface.
Fig. a Division direction when
there is no inner surface
Fig. b Division direction when
there is an inner surface
(2)Division direction for outer surface machining (normal process)
If the end surface is cut at the same time, the area is divided as shown
in Fig.a when there is no inner surface and as shown in Fig.b when
there is an inner surface. If the end surface is separately cut, the area
is divided as shown in Fig.c regardless of whether there is an inner
surface.
Fig.a Division direction when
there is no inner surface
Fig.b Division direction when
there is an inner surface
Fig. c When only the outer surface is cut
4.4
AREA DIVISION

Leave a Reply

Your email address will not be published. Required fields are marked *