Fanuc Symbol CAPi T Operators Manual

B–63304EN/02
4. DETAILS OF AUTOMATIC
PROCESS DETERMINATION
AND NOTES ON ITS USE
AUTOMATIC PROCESS
DETERMINATION FUNCTION
645
(3)Division direction for inner surface machining (normal process)
The area is divided as shown in Fig. a and Fig. b regardless of whether
an element of the part intersects with the Z–axis.
Fig. a Division direction when an element
of the part intersects with the Z–axis
Fig. b Division direction when no element
of the part intersects with the Z–axis
(4)Division direction for grooving
The area is divided into the groove on the end surface (Fig. a), groove
on the outer surface (Fig. b), and groove on the inner surface (Fig. c).
Fig. a Groove on the end surface Fig. b Groove on the outer surface
Fig. c Groove on the inner surface
Note) DS and DE depend on the tool figure.

Leave a Reply

Your email address will not be published. Required fields are marked *