Fanuc Symbol CAPi T Operators Manual

B–63304EN/02
4. DETAILS OF AUTOMATIC
PROCESS DETERMINATION
AND NOTES ON ITS USE
AUTOMATIC PROCESS
DETERMINATION FUNCTION
647
In residual machining and threading, two or more sections can be
machined using the same tool.
If a center drilling process or bar feeding process is set in machining
procedure data, that process is always determined regardless of the part
figure. However, the process is not determined when no center drilling
tool or bar feeding tool is registered in tooling information or tool data.
When not using a center drilling process or bar feeding process, do not set
the process in machining procedure data, or delete the process after all
processes are determined.
The bar feeding type is automatically determined based on the setting in
the following system parameters:
Pull–out
method 1
Pull–out
method 2
Slide–stop
method 1
Slide–stop
method 2
No.152 (CAX) Undefined Set Undefined Undefined
No.153 (CAZ) Set Undefined Set Undefined
No.154 (WG) Set Set Undefined Undefined
No.155 (CEZ) Undefined Undefined Set Undefined
No.152: Clearance when the tool approaches for bar feeding (CAX)
No.153: Clearance when the tool approaches for bar feeding (CAZ)
No.154: Position at which the fingers pinch the workpiece during bar
feeding (WG)
No.155: Amount of tool retraction during bar feeding (CEZ)
NOTE
The B option for the automatic process determination
function is necessary for automatically determining the bar
feeding process.
4.5
RESIDUAL
MACHINING AND
THREADING
4.6
CENTER DRILLING
AND BAR FEEDING

Leave a Reply

Your email address will not be published. Required fields are marked *