Fanuc Symbol CAPi T Operators Manual

AUTOMATIC PROCESS
DETERMINATION FUNCTION
B–63304EN/02
4. DETAILS OF AUTOMATIC
PROCESS DETERMINATION
AND NOTES ON ITS USE
648
When the inner surface is machined with the automatic process
determination function, multitier drilling can be performed using drills
with different diameters.
When performing multitier drilling, set the following setting data:
No.50: Minimum inner diameter which can be machined with the
inner surface tool (unit: mm)
Initial value: Undefined
Set the minimum inner diameter which can be machined with the prepared
inner surface machining tool. The automatic process determination
function determines the process so that a diameter less than the set value
is machined with drills.
Fig. 1
WARNING
1 The automatic process determination function always
machines a diameter less than the set value with drills
regardless of the values in setting data No.52 and 53.
2 If the value is undefined, the automatic process
determination function determines the process so that all
inner surface are machined with the inner surface tool.
3 The automatic process determination function specifies
cutting areas so that machining for a diameter less than the
set value does not require an inner surface tool.
No.51: Maximum inner diameter which can be machined with drills
(unit: mm)
Initial value: Undefined
Set the maximum inner diameter which can be machined with drills. The
automatic process determination function machines a diameter less than
the set value with drills. Multitier drilling can be performed for a diameter
less than the set value.
4.7
MULTITIER DRILLING
(B OPTION FOR THE
AUTOMATIC
PROCESS
DETERMINATION
FUNCTION)

Leave a Reply

Your email address will not be published. Required fields are marked *