Fanuc Symbol CAPi T Operators Manual

B–63304EN/02
4. DETAILS OF AUTOMATIC
PROCESS DETERMINATION
AND NOTES ON ITS USE
AUTOMATIC PROCESS
DETERMINATION FUNCTION
649
Fig. 2
WARNING
If the value is undefined, the automatic process
determination function determines the process so that all
inner surfaces are machined with drills.
Setting data Nos.52 and 53 determine whether drills are used for
machining the inner surface with a diameter greater than the value in
setting data No.50 (minimum inner diameter which can be machined with
the inner surface tool) and less than the value in setting data No.51
(maximum inner diameter which can be machined with drills).
The inner surface with a diameter less than the value in setting data No.50
is always machined with drills regardless of the values in setting data
No.52 and 53.
No.52 and 53 are
effective.
No.52 and 53 are
not effective.
Fig. 3
No.52: Minimum allowance for drilling (unit: mm)
Initial value: Undefined
Set the minimum allowance on the inner surface to be drilled. The inner
surface is drilled when the allowance is more than the set value.

Leave a Reply

Your email address will not be published. Required fields are marked *